The Arduino sketch required to drive this display requires quite a bit of dynamic memory, meaning that it is not going to fit on a smaller controller like an ATmega328. Control of the OLED is based on our new HyperDisplay library and any controller with larger RAM should have no problem. In addition, your 3.3V source should be robust enough to supply around 400mA to the display.
Note: The I2C address of the Graphical OLED is 0x3C and is jumper selectable to 0x3D. A multiplexer/Mux is required to communicate to multiple Graphical OLED sensors on a single bus. If you need to use more than one Graphical OLED sensor consider using the Qwiic Mux Breakout.
The SparkFun Qwiic Connect System is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces the amount of required PCB space, and polarized connections mean you can't hook it up wrong.
- 128x56 transparent pixels (128x64 total pixels)
- Display area 35.5 x 18mm
- Glass area 42mm x 27.16mm
- 1-bit color depth
- I2C or SPI operation
- 400 kHz I2C, 10 MHz SPI
- I2C Addresses: 0x3C (Default), 0x3D
- Qwiic compatible and standard PCB footprint
- Operates and communicates at 3.3V
- Less than 200 mA current draw pixels all-on
- Eagle Files
- Graphical OLED DataSheet
- Hookup Guide
- HyperDisplay Graphics Library
- SSD1309 HyperDisplay Mid Level Library
- Transparent Graphical Bottom Level Library
Emballagestørrelse: 12,2 cm 6,2 cm 0,7 cm
Vægt: 0,007 kg
Kunder der har købt dette produkt har også købt