Spring til hovedindhold (tryk på Enter)

Other

Varenr. SEN0325

6+1 Microphone Array

188,75
DKK

På fjernlager Bestil før Onsdag kl 20 og varen afsendes ugen efter

Køb flere og spar:

188,75 DKK pr. stk. -
168,00 DKK pr. stk.
Spar 11%
148,00 DKK pr. stk.
Spar 22%

This item is only sold in badges of .

eller

Du skal vælge en variant.
Minimumsmængde nået.
Maksimal mængde nået
  • Fri fragt ved køb over 999 kr

    Til pakkeshop i DK Læs mere.

  • 60 dages returret

    Se venligst Handelsbetingelser Læs mere.

  • Danmarks største udvalg

    Over 4000 produktnumre Læs mere.

Documents

  • Datasheet
  • Product Data
  • Introduction

    This Microphone adopts MSM261S4030H0 high sensitivity digital silicon chip to form 6+1 microphone array, by which to solve some problems such as noise and echo suppression, reverb cancellation, single or multiple sound sources localization, and so on. The product features I2S output, onboard SK9822 series RGB LED, two-wire control color.

    MSM26S4030H0 is omnidirectional, bottom ported, I2S digital output MEMS microphone chip. I2S is a general-purpose digital audio interface and widely used in DSP and digital audio processing field. In a conventional audio system, the audio signal collected by the microphone will be converted into analog voltage and output, and then processed by the main controller chip after being changed into digital signal and encoded through the ADC of codec. However, the product of MSM261S4030H0 series has built-in 24bit I2S audio port, so without adding extra Codec, it is able to realize full digital signal connections with DSP or MCU. The raw digital audio signal is directly output to the main controller chip. As a result, the complexity of designing signal chains will be greatly reduced, which allows the product to hold advantages in size, cost, power consumption, and anti-interference.

    Nowadays, personal portable electronic products have been gradually becoming dominant in the consumer market. This kind of silicon-made microphone learns the advantages of semiconductor technology and combines high repeatability of production, excellent sound performance, and great expansibility. Therefore, it can be said with confidence that in the near future, the traditional ECM(electret condenser microphone) will be replaced by the low cost and high-performance MEMS.

    Features

    • MEMS Microphone: 6+1 MSM261S4030H0 form an array
                                              Sound pressure level: 140 dB SPL                                      

                                              Sensitivity: -26(dB,dBFS@1kHz 1pa)                                      

                                              Signal to noise ratio: 57dB(20kHz bandwidth, A-weighted)

    • Output: digital I2S output
    • Light: 12 LEDs form a ring light array, 256 level color set, 32 level brightness set 
                      Viewing Angle: 120 degree                  

                      Synchronous of two-lane                

                      Choose positive or negative output RGB tri-color LED                

                      Current 20mA per color, 60mA total at full brightness

    Specification

    • Dimension: 78.1×88.8mm/3.07×3.50”

    • Input Voltage: 3.3V±0.2V(DC)

    • Input Current: >750mA(full brightness)

    • Connector: 2*5P 2.54mm header and 10P 0.5mm FPC

    • Operating Temperature: -30℃~85℃

    Shipping List

  • 6+1 Microphone Array x1
  • Relaterede varer