Sink With AL Heat adhesive tape 13x13x7mm, DFRobot:FIT0191, køb her 16,63 DKK

Mængderabat

AL Heat Sink (With adhesive tape) - 13*13*7mm

DFRobot

Varenr. FIT0191

AL Heat Sink (With adhesive tape) - 13137mm

16,63

DKK

På fjernlager Bestil før Onsdag kl 20 og varen afsendes ugen efter

Køb flere og spar:

1 stk.	16,63 DKK pr. stk.	-
5 stk.	14,50 DKK pr. stk.	Spar 13%
10 stk.	12,30 DKK pr. stk.	Spar 26%

This item is only sold in badges of .

eller

Du skal vælge en variant.

Minimumsmængde nået.

Maksimal mængde nået

Fri fragt ved køb over 999 kr

Til pakkeshop i DK Læs mere.
60 dages returret

Se venligst Handelsbetingelser Læs mere.
Danmarks største udvalg

Over 4000 produktnumre Læs mere.

Introduction

This AL Heat Sink(With adhesive tape) and a U.S. made 3M-8810 thermal adhesive tape on the back of the heatsink. It doesn't require a coat layer of heat conduction glue on the heatsink. Simply remove the blue protective film on the thermal adhesive tap and stick in the desired chip parts. The adhesive is strong and long lasting.

This heat sink can be used with Allegro A4983/A4988 stepper driver.

Notice: Make sure the surface of the component is clean before sticking the heatsink.

Subtotal	0,00
Levering	0,00
Total:	0,00
Heraf moms	0,00

products

AL Heat Sink (With adhesive tape) - 13137mm

Introduction

Specification

Shipping List

Relaterede varer

AL Heat Sink (With adhesive tape) - 13*13*7mm

Introduction

Specification

Shipping List

Relaterede varer

AL Heat Sink (With adhesive tape) - 13137mm