Spring til hovedindhold (tryk på Enter)

Other

Varenr. DFR0808

ESP32-C3-DevKitC-02 Development Board

241,25
DKK

På fjernlager Bestil før Onsdag kl 20 og varen afsendes ugen efter

Køb flere og spar:

241,25 DKK pr. stk. -
217,00 DKK pr. stk.
Spar 10%
193,00 DKK pr. stk.
Spar 20%

This item is only sold in badges of .

eller

Du skal vælge en variant.
Minimumsmængde nået.
Maksimal mængde nået
  • Fri fragt ved køb over 999 kr

    Til pakkeshop i DK Læs mere.

  • 60 dages returret

    Se venligst Handelsbetingelser Læs mere.

  • Danmarks største udvalg

    Over 4000 produktnumre Læs mere.

Documents

  • User Guides
  • Introduction

    ESP32-C3-DevKitC-02 is an entry-level development board based on ESP32-C3-WROOM-02, a general-purpose module with 4 MB SPI flash.

    This board integrates complete Wi-Fi and Bluetooth LE functions.

    Most of the I/O pins are broken out to the pin headers on both sides for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-C3-DevKitC-02 on a breadboard.


    Description of Components

    Key Component Description
    ESP32-C3-WROOM-02 ESP32-C3-WROOM-02 from Espressif is a powerful and general-purpose module that offers Wi-Fi and Bluetooth LE coexistence. It has a PCB antenna and a 4 MB SPI flash.
    5 V to 3.3 V LDO Power regulator that converts a 5 V supply into a 3.3 V output.
    5 V Power On LED Turns on when the USB power is connected to the board.
    I/O Connector All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board.
    Boot Button Download button. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port.
    Micro-USB Port USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-C3 chip.
    Reset Button Press this button to restart the system.
    USB-to-UART Bridge Single USB-to-UART bridge chip provides transfer rates up to 3 Mbps.
    RGB LED Addressable RGB LED, driven by GPIO8.


    Pin Header

    Features

  • Integrates complete Wi-Fi functions.
  • Integrates complete Bluetooth LE functions.
  • Specification

  • ESP32-C3 embedded, 32-bit RISC-V single-core processor, up to 160 MHz
  • 384 KB ROM
  • 400 KB SRAM
  • 8 KB RTC SRAM
  • 40 MHz crystal oscillator
  • 4 MB SPI flash
  • Operating Voltage/ Power supply: 3.0~3.6 V
  • Operating Temperature Range: –40~85°C
  • Shipping List

  • ESP32-C3-DevKitC-02 Development Board ×1
  • Relaterede varer