Spring til hovedindhold (tryk på Enter)

DFRobot

Varenr. DFR0171

Gravity: Screw Shield V2 for Arduino

122,50
DKK

På fjernlager Bestil før Onsdag kl 20 og varen afsendes ugen efter

Køb flere og spar:

122,50 DKK pr. stk. -
108,00 DKK pr. stk.
Spar 12%
94,00 DKK pr. stk.
Spar 23%

This item is only sold in badges of .

eller

Du skal vælge en variant.
Minimumsmængde nået.
Maksimal mængde nået
  • Fri fragt ved køb over 999 kr

    Til pakkeshop i DK Læs mere.

  • 60 dages returret

    Se venligst Handelsbetingelser Læs mere.

  • Danmarks største udvalg

    Over 4000 produktnumre Læs mere.

Introduction

The DFRobot Arduino-Compatible Screw Shield is a terminal expansion board that allows you to screw in jumper wires to a screw terminal for a much stronger and secure connection for your I/O and power pins. Feel secure with this arduino-compatible screw shield.
The screw shield v2 from DFRobot also extend the power supply pins for the signal pins. You could directly plugin the sensors and the servos to the screw shield v2. The pin headers are color coded for easy identification of analog, digital, and power pins.
We commonly use:Green for digital I/O;Blue for Analog I/O;Red for Voltage

Specification

  • I/O Screw terminals
  • 3-Pin male headers for easy sensor/servo connection
  • Colored pin headers
  • Size: 32x65mm(1.26"x2.56")

Shipping List

  • Screw Shield V2 For Arduino x1

Relaterede varer