Spring til hovedindhold (tryk på Enter)

Other

Varenr. DFR0812

ESP32-S2-Saola-1M Development Board

226,25
DKK

På fjernlager Bestil før Onsdag kl 20 og varen afsendes ugen efter

Køb flere og spar:

226,25 DKK pr. stk. -
204,00 DKK pr. stk.
Spar 10%
181,00 DKK pr. stk.
Spar 20%

This item is only sold in badges of .

eller

Du skal vælge en variant.
Minimumsmængde nået.
Maksimal mængde nået
  • Fri fragt ved køb over 999 kr

    Til pakkeshop i DK Læs mere.

  • 60 dages returret

    Se venligst Handelsbetingelser Læs mere.

  • Danmarks største udvalg

    Over 4000 produktnumre Læs mere.

Documents

  • Product wiki
  • Introduction

    ESP32-S2-Saola-1 is a small-sized ESP32-S2-based development board. Most of the I/O pins are broken out to the pin headers on both sides for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-S2-Saola-1 on a breadboard.

    ESP32-S2-Saola-1 is equipped with ESP32-S2-WROOM module, a powerful and generic Wi-Fi MCU module that has a rich set of peripherals. It’s an ideal choice for a wide variety of application scenarios like wearable electronics and smart home. The board has PCB onboard antenna, and 4MB SPI flash.


    Description of Components

    ESP32-S2-Saola-1M Development Board

    Key Component

    Description

    ESP32-S2-WROVER

    ESP32-S2-WROVER is a powerful, generic Wi-Fi MCU module that integrates ESP32-S2. It has a PCB antenna, a 4 MB external SPI flash and an additional 2 MB PSRAM.

    I/O Connector

    All available GPIO pins (except for the SPI bus for flash and PSRAM) are broken out to the pin headers on the board. Users can program ESP32-S2 chip to enable multiple functions such as SPI, I2S, UART, I2C, touch sensors, PWM etc.

    USB to UART Bridge

    Single USB-UART bridge chip provides transfer rates up to 3 Mbps.

    Boot Button

    Download button. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port.

    Reset Button

    Reset button.

    3.3 V Power On LED

    Turns on when the USB power is connected to the board.

    Micro-USB Port

    USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-S2 chip.

    RGB LED

    Addressable RGB LED (WS2812), driven by GPIO18.


    Block Diagram

    ESP32-S2-Saola-1M Development Board

    Specification

  • ESP32-S2 chip, Xtensa single-core 32-bit LX7 Microcontroller
  • 128 KB ROM
  • 320 KB SRAM
  • 16 KB RTC SRAM
  • 40 MHz crystal oscillator integrated
  • 4 MB SPI flash
  • Operating/Supply Voltage: 3.0 ~ 3.6 V
  • Recommended Operating Temperature: –40 ~ 85 °C
  • Shipping List

  • ESP32-S2-Saola-1M Development Board x1
  • Relaterede varer